Ford TPMS Reset: Easy Guide

Prepare Your Vehicle Before Reset

Before starting the Ford TPMS reset, make sure all four tires are inflated to the correct pressure. The recommended PSI is usually listed on the driver-side door sticker.

Incorrect tire pressure will prevent the system from completing the relearn process. Also, park the vehicle safely and turn the ignition to the ON position without starting the engine.

Enter TPMS Relearn Mode

Next, activate the TPMS relearn function using the dashboard settings. On most Ford models, the steps are:

Turn ignition ON (engine off)
Go to vehicle settings on the dashboard
Select Tire Pressure or TPMS Reset/Relearn option

When activated, the horn may chirp, indicating the system is ready to register sensor positions. This is often called the Ford TPMS reset after tire rotation procedure.

Relearn Each Tire Sensor

Once the system is in relearn mode, you must activate each tire sensor in the correct order:

Start with the front left tire, then front right, followed by rear right, and finally rear left.

A TPMS tool can be used, or on some older Ford vehicles, you can slightly reduce tire pressure until the horn beeps. Each beep confirms that the sensor has been successfully recognized.

Complete the Reset Process

After all four sensors are learned, the system will blink the TPMS warning light and then turn it off automatically. This means the Ford tire pressure monitoring system reset procedure has been completed successfully.

If the warning light remains on, drive the vehicle at speeds above 25 mph (40 km/h) for 10 to 15 minutes to allow the system to fully recalibrate.

Final Check