The Ford Explorer does not have a dedicated TPMS reset button on most model years. Instead, the Tire Pressure Monitoring System (TPMS) automatically relearns tire pressure after the tires are properly inflated and the vehicle is driven. The reset method depends on the model year and the type of TPMS installed.
2006–2010 Ford Explorer
Early fourth-generation Explorer models may require a TPMS training procedure after replacing a sensor or rotating tires.
Steps:
Park the vehicle and set the parking brake.
Turn the ignition from OFF to RUN three times, ending in the RUN position.
Press and release the brake pedal.
Turn the ignition OFF.
Again, cycle the ignition OFF to RUN three times, ending in RUN.
The horn will sound once, indicating TPMS training mode.
Starting with the left front tire, use a TPMS activation tool until the horn sounds.
Repeat for the right front, right rear, and left rear tires.
After the final tire is learned, the horn will sound twice, confirming successful registration.
2011–2019 Ford Explorer
Most fifth-generation Explorer models do not include a TPMS reset button. The system continuously monitors tire pressure and automatically updates after correct inflation.
If the Tire Pressure Monitor Fault message remains:
Inflate all tires to the pressure listed on the driver's door sticker.
Drive the vehicle at above 20 mph (32 km/h) for approximately 10–20 minutes.
If TPMS sensors were replaced or tires were rotated, perform the TPMS sensor training procedure using a compatible TPMS programming tool.
2020–Present Ford Explorer
Sixth-generation Ford Explorer models also do not use a manual TPMS reset button.
To clear the warning:
Adjust all tire pressures to the recommended specification.
Drive normally for 10–30 minutes at speeds above 20 mph (32 km/h).
The TPMS warning light should turn off automatically once the system receives valid pressure data from all sensors.
If new TPMS sensors have been installed, a TPMS relearn procedure using a TPMS scan tool or activation tool may be required before the system recognizes the new sensor IDs.
Where Is the TPMS Reset Button?
For nearly all 2006–2026 Ford Explorer models, there is no physical TPMS reset button located under the dashboard, glove box, steering column, or center console. Ford designed the Explorer to use an automatic TPMS relearn system, with manual sensor training only when components are replaced or serviced.
When Is TPMS Relearning Required?
A TPMS relearn or sensor training procedure is typically required after:
Replacing one or more TPMS sensors.
Installing a new set of wheels.
Rotating tires on older Explorer models that require sensor location registration.
Replacing the Body Control Module (BCM) or TPMS receiver.
Persistent TPMS fault messages after all tire pressures have been corrected.
Conclusion
If you are searching for the Ford Explorer TPMS reset button, the answer is that most Explorer models do not have one. The TPMS automatically resets after the tires are inflated to the correct pressure and the vehicle is driven. Only sensor replacement or certain maintenance procedures require entering TPMS training mode with the proper activation tool.